The MDPE Tee Compression Fitting splits a 50mm MDPE supply line to a 1.5" BSP Male thread, giving tradespeople a reliable branch connection for water or irrigation systems. Key features include a PN10 pressure rating (up to 10 bar), MDPE material with good chemical resistance, and a threaded compression joint designed to form a tight seal when assembled correctly. The 90-degree branch off the main run makes it practical for routing water to taps, sprinklers, or ancillary equipment without welding or solvent welding. Expect durable performance in varying weather and temperature conditions, with a long service life typical of MDPE fittings. This fitting is ideal for domestic water networks, agricultural irrigation, and light industrial piping where a secure branch is required from a 50mm MDPE line to a 1.5" BSPM outlet. It supports straightforward installation in systems that use MDPE pipe and PN10-rated components, helping crews avoid lengthy, complex jointing methods while maintaining system integrity. Installation tips to get the best result: ensure the 50mm MDPE pipe ends are clean and square, and cut straight. Insert the pipe fully into the compression nut and olive before tightening the nut with the appropriate spanner. Tighten to the manufacturer’s recommended torque without overtightening, then pressurise the line and check for leaks. Regular inspection of joints in exposed or outdoor installations is sensible, especially where temperature fluctuations occur. Durability and maintenance: MDPE fittings resist most common chemicals and acids found in residential and light industrial environments, helping reduce corrosion-related maintenance. The compression connection is designed for repeatable assembly and disassembly if adjustments are needed, subject to proper re-tightening and re-sealing. This makes the 50mm to 1.5" BSPM MDPE Tee a practical, cost-conscious choice for connecting branch lines in water supply and irrigation schemes.